Maintenance
Keep the maintenance of the
machine tool
during the
operation
to guarantee the
accuracy and
service
life
of the machine.
1. ln order to retain the machine's precision and functionality, it is essential to treat it with care, keep
it clean and grease and lubricate it regularly. Only through good care, you can be sure that the
working quality
of
the machine will remain constant.
Disconnect the machine
plug from the
mains
supply
whenever
you
carry out cleaning, maintenance
or
repair work!
2. Lubrication all slideways lightly before every use. The leadscrew
must
aise be lightly lubricated
with lithium base grease.
3.
During the opèration, the chips what falls onto the sliding surface should be cleaned timely, and
the inspection should be often made to prevent chips falling into sliding ways. Asphalt felt should
be cleaned at
certain time.
Do ·not remove
the
chips
with your bare hands. There is a risk
of
cuts due to sharp-edged chips.
4. After the operation every day, eliminate all the chips and clean different part of the machine and
apply machine oil to prevent rusting.
5. ln order to maintain the machining accuracy, take care of the arbor, drawbar, the surface of the
worktable and the guide way and avoid mechanical damage and the wear due to improper guide.
6. If
the
damage is found, the maintenance should be done immediately.
- 13 -
To Next Page
Loading...
