HBM BF 28 - Contents of Shipping Container; Unpacking and Clean-up Procedures

i
Lt_ WARNING
Read and understand the entire contents of this
Manual
before attempting set•up or
operation!
Failure to comply may cause serious injure!
CONTENTS OF SHIPPING CONTAINER
z
1 Milling & Drilling Machine
1 3/8 Drawbar
1 Digital Scale & Speed Readout (Optional)
1
Test Flow Chat
1 Operator manual
1
Toolbox & Tools
Toolbox Contents (Fig. 01)
1
Oil Gun
1
MT2Arbor
2 Double End Spanner (17-19)
6
Hex Socket Wrench (2.5,3,4,5,6,8mm)
1
Flat Blade Screwdriver
1
Cross Blade Screwdriver
4
Handle
·2
M1 O 'T' Screw
2 M10 Washer
2
M10 Nut
Unpacking
and
Clean-up
1. Finish removing the wooden crate from around
the mill/drill.
2. Unbolt the machine from
the crate
bottom.
3. Sling mill/drill with the proper equipment.
4. Clean all
rust
protected surfaces using a mild
commercial solvent, kerosene or diesel
fuel.
Do not
use paint thinner, gasoline, or lacquer thinner.
These
will damage painted surfaces. Cover all
cleaned surfaces with
a
light
film
of machine oil.
- 6 -
D
Fig. 01