Need help?Do you have a question about the HBM QuantumX CX22 and is the answer not in the manual?
General| Communication Interface | Ethernet |
|---|---|
| Sampling Rate per Channel | 100 kS/s |
| Input Voltage Range | ±10 V |
| TEDS Support | Yes |
| Protection Class | IP40 |
| Resolution | 24 bit |
| Input Voltage | 10 V to 30 V DC |
| Sampling rate | Up to 100 kS/s per channel |
| Interface | Ethernet |
| Power supply | 10 V to 30 V DC |
| Operating Temperature | -20 °C to +60 °C |
Describes the intended use and precautions for the module and connected transducers.
Lists critical safety rules for operating the module and its connections.
Describes methods for synchronizing QuantumX modules for precise time-aligned measurements.
Details the functions of the QuantumX Assistant software for system configuration and operation.
Describes the capabilities of the catman®AP software for measurement tasks and analysis.
Guides on how to check and update module firmware using Ethernet.
Explains how to connect the DC supply voltage to QuantumX modules.
Covers various methods for connecting QuantumX modules to a PC via Ethernet and FireWire.
Explains connecting QuantumX modules to a PC using FireWire.
Guides on setting up FireWire connections for QuantumX modules.
Instructions on updating module firmware using Ethernet.
Introduces the MX840 universal amplifier and its connectable transducers.
Introduces the MX840A universal amplifier and its connectable transducers.
Details the MX410 amplifier and its connectable transducers.
Introduces the MX460 amplifier and its connectable transducers.
Introduces the MX1601 amplifier and its connectable transducers.
Introduces the MX1615 amplifier and its supported transducer types.
Describes the MX410 module's analog outputs and math functions.
To Next Page
