Need help?Do you have a question about the HBM QuantumX MX440A and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| Sampling rate per channel | up to 19.2 kHz |
| Input voltage range | ±10 V |
| Resolution | 24 bit |
| TEDS support | Yes |
| Interfaces | Ethernet, CAN |
| Power supply | 10-30 V DC |
| Input types | Voltage, IEPE, RTD, Resistance, Thermocouple |
Lists general safety rules for operating the module and connected devices.
Outlines dangers from improper installation and operation by untrained personnel.
Defines qualified personnel and their responsibilities for installation and operation.
Details methods for synchronizing QuantumX modules for accurate measurements.
Describes the functions and features of the QuantumX Assistant software.
Details how to connect the DC supply voltage to QuantumX modules.
Covers various methods for connecting QuantumX modules to a PC.
Explains how to connect QuantumX modules using FireWire.
Explains Transducer Electronic Data Sheet (TEDS) technology and its use.
Shows the pin assignment for the MX840 connector plug.
Shows the pin assignment for the MX840A connector plug.
Details the pin assignment for the MX410 universal amplifier.
Explains connecting IEPE piezoelectric sensors and supported modules.
Explains connections for thermocouples with cold-spot compensation.
Describes the MX471 module for high-performance CANbus and QuantumX system connection.
Details how to send measured quantities as CAN messages using the MX471.
To Next Page
