Need help?Do you have a question about the HBM QuantumX MX840A and is the answer not in the manual?
General| Brand | HBM |
|---|---|
| Model | QuantumX MX840A |
| Category | Control Unit |
| Language | English |
Defines intended use for measurement and control tasks only, adhering to manual specifications and regulations.
Covers power connection limits, EMI shielding, access protection, and network malfunction handling.
Details synchronization via FireWire, EtherCAT, NTP, and IRIG-B for precise time-based measurements.
Outlines functions for system config, module management, channel setup, and signal measurement/analysis.
Guides on checking and updating module firmware using QuantumX Assistant and firmware update software.
Details the BPX001 backplane for connecting up to 9 modules, its power supply, and protection.
Explains DC voltage connection (10-30V), power consumption, and voltage distribution rules.
Details Ethernet/FireWire connections (single/multiple), setup, sync, and troubleshooting.
Explains TEDS for transducer ID, data storage, and auto amplifier configuration.
Provides general info on MX471's CAN nodes, protocols, and parameterization.
Covers MX410's 8 analog outputs, peak detection, and RMS channels for virtual signal generation.
Explains MX878's analog outputs, math functions (Add/Multiply, Matrix), and signal generation.
Details MX471's CAN output, PDO transmission, CAN parameterization, and CCP/xCP-on-CAN support.
To Next Page
