28 Software
HBM QuantumX
3.6 TEDS Editor
HBM’s TEDS Editor enables TEDS data to be read, edited and written directly via a
measurement channel or the HBM TEDS dongle. When retrofitting TEDS, the editor provides
corresponding templates for the different transducer types. Some templates can be saved
and loaded.
Chapter 6.1.3 describes TEDS in general.
3.7 DIAdem driver
DIAdem is a graphic programming system from the company ”National Instruments”.
DIAdem provides corresponding library modules for the complete data flow, ranging from
measurement acquisition through analysis to reporting.
HBM’s DIAdem driver enables measurement data acquisition using the following QuantumX
amplifiers: MX840, MX840A, MX440A, MX410, MX460 and MX1609.
Latest information can be found in the corresponding release notes at www.hbm.com.
3.8 DASYLab driver
DASYLab is a graphic programming system from the company ”National Instruments”.
The acronym stands for ”Data Acquisition System Laboratory”. The main application areas
for DASYLab are in measurement, control and automation technology.
The graphic library modules enable interfaces to be controlled, for example, inputs and
outputs, signal conditioning and analysis, control, visualization and data storage.
The partner company IMP sells a DASYLab driver for measurement data acquisition using
the follwing QuantumX modules: MX840, MX840A, MX440A and MX1609.
Latest information can be found at www.impkoeln.de.
To Next Page
Loading...
