To Next PageTo Next PageHow to fix Health O Meter 600KL that do not turn on?
If your Health O Meter Scales do not turn on, there are several potential causes. First, the battery might be dead, so try replacing it. Second, the electrical outlet could be faulty; try a different outlet. Third, the adapter may be broken, indicated by the LED light at the back of the display module not working; in this case, replace the adapter.
What to do if Health O Meter 600KL Scales display shows “LO Bat” message?
If the display of your Health O Meter Scales shows a “LO Bat” message, it means the batteries are depleted. Replace the batteries according to the provided instructions.
Why Health O Meter Scales showing questionable weight or not zeroing?
If your Health O Meter Scales are showing questionable weight or not zeroing, there are several possible reasons. An external object might be interfering with the scale; remove it. The display might not have shown ‘0.0’ before weighing; ask the patient to get off the scale, zero it, and begin the weighing process again. The scale might not be on a level floor; place it on a level floor and restart the weighing process. Finally, the scale might be out of calibration; check the weight with a known weight value.
What to do if Health O Meter Scales display shows “OVER”?
If the display on your Health O Meter Scales shows “OVER”, it means the load on the scale exceeds its capacity (600 lb/272 kg). Remove the excess weight and use the scale within its specified limits.
What does Err 6 mean on Health O Meter 600KL Scales?
If your Health O Meter Scales display “Err 6”, it indicates a high saturation state (high A/D). This means the load cell cable is not connected correctly. Check the connection, cables, and mechanical connection.
What does Err 7 mean on Health O Meter 600KL?
If your Health O Meter Scales display “Err 7”, it indicates a low saturation state (low A/D). Refer to the troubleshooting steps for Err 6, as the cause and solution are the same.
What does Err 3 mean on Health O Meter 600KL?
If your Health O Meter Scales display “Err 3”, it means the weight is unstable, and calibration cannot be performed. Check the load cells' mechanical surroundings to ensure nothing is touching them and that the cables are securely connected.
What does Err 2 mean on Health O Meter Scales?
If your Health O Meter Scales display “Err 2”, it means the weight loaded is too low, and calibration cannot be performed. While in the calibration procedure, add more weight in load mode.
What does Err 5 mean on Health O Meter 600KL Scales?
If your Health O Meter Scales display “Err 5”, it means calibration is disabled. Locate the silver extended screw and plastic tab on the back of the display. Remove the tab to access the push button underneath. Press and release the button once to enable calibration. When finished, toggle the calibration switch to enable.
What does Err 1 mean on Health O Meter 600KL Scales?
If your Health O Meter Scales display “Err 1”, it indicates a mathematical mistake due to division by zero, meaning the calibration factor cannot be calculated. This will show when trying to calibrate without any calibration weight.
General| Brand | Health O Meter |
|---|---|
| Model | 600KL |
| Category | Scales |
| Language | English |
