To Next PageTo Next PageHow to fix a Healthrider Softstrider HRTL59215.0 Treadmill that does not turn on?
If your Healthrider Treadmill does not turn on, ensure that the power cord is plugged into a surge suppressor and that the surge suppressor is plugged into a properly grounded outlet. Also, make sure that the key is inserted into the console. If the switch has tripped, wait five minutes and then press the switch back in.
How to fix Healthrider Treadmill walking belt slowing down?
If the walking belt on your Healthrider Treadmill slows down when you walk on it, it might be overtightened. To resolve this, remove the key and unplug the power cord. Then, using the hex key, turn both idler roller screws counterclockwise, 1/4 of a turn.
How to calibrate the incline on a Healthrider Treadmill?
If the incline of your Healthrider Treadmill does not change correctly, hold down the Stop button and the Speed increase button, insert the key into the console, and then release the Stop button and the Speed increase button. Next, press the Stop button and then press the Incline increase or decrease button. If the incline system does not begin calibrating, press the Stop button again, and then press the Incline increase or decrease button again.
What to do if my Healthrider Treadmill power turns off during use?
If your Healthrider Treadmill's power turns off during use, there could be a few reasons. First, the switch may have tripped; if this is the case, wait five minutes, and then press the switch back in. Also, ensure the power cord is securely plugged in. Another solution is to remove the key from the console and then reinsert it.
What to do if the Healthrider Softstrider HRTL59215.0 Treadmill walking belt is off-center?
If the walking belt on your Healthrider Treadmill is off-center, it likely means the walking belt has shifted. If it has shifted to the left, use the hex key to turn the left idler roller screw clockwise 1/2 of a turn. If it has shifted to the right, turn the left idler roller screw counterclockwise 1/2 of a turn. If the walking belt slips when walked on, unplug the power cord and use the hex key to turn both idler roller screws clockwise, 1/4 of a turn.
Why does my Healthrider Softstrider HRTL59215.0 Treadmill console stay on after removing the key?
If the console displays on your Healthrider Treadmill remain lit even after removing the key, it's likely that the demo mode is turned on. To turn off the demo mode, hold down the Stop button for a few seconds.
General| Running Area | 20" x 55" |
|---|---|
| Incline | 12 levels |
| Weight Capacity | 300 Lbs. |
| Folding | Yes |
| Programs | 18 Workout Apps |
| Speed | 0.5 - 10 mph |
| Speed Range | 0.5 - 10 mph |
| Motor Power | 2.5 HP |
| Motor | 2.5 HP |
Keep hands and feet away from the treadmill area during operation.
Read manual, follow safety instructions, keep children away, remove key when not in use.
Connect the treadmill power cord to a surge suppressor and plug into a grounded outlet.
Adjust incline to zero, remove key, unplug cord, and lift frame to secure.
Fold treadmill, hold frame and handrail, place foot on wheel, and pull back.
Hold frame, pull latch knob, lower frame past pin, and place to floor.
Use heart rate as a guide to find proper intensity for fat burning and aerobic exercise.
Includes warming up, training zone exercise, and cooling down for effective workouts.
Complete three workouts weekly, with rest days, to maintain or improve condition.
