EasyManua.ls Logo

Heart Interface LINK 20 User Manual

Heart Interface LINK 20
39 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
03/03/97
1
Manual Part # 890028
INSTALLERS: PLEASE LEAVE THIS MANUAL WITH THE OWNER.
IT CONTAINS IMPORTANT OPERATING INFORMATION.
APPLICATIONS: The Link 20 provides instrumentation of two banks of
batteries. The Link 20 does not control an inverter/charger. For installations
involving a Freedom inverter/charger and two battery banks, the Link 2000
is recommended. If a Freedom inverter/charger and one battery is anticipated,
the Link 1000 is recommended. For instrumentation of a single battery bank
with no inverter/charger controls, the Link 10 is ideal.
OPERATION: Instructions on how to operate your Link 20 begin on page 4
of this manual.
INSTALLATION: This manual contains easy to follow installation instructions
beginning on page 32.
WARRANTY ISSUES: Warranty issues will be resolved directly through Heart
Interface. Please do not route warranty issues through your dealer.
21440 68
th
Ave. So. Kent, WA 98032
(206) 872-7225 Toll Free 1-800-446-6180
Sales\D:\work\link20\link20Revb.pm6
OWNER'S MANUAL
LINK 20
Question and Answer IconNeed help?

Do you have a question about the Heart Interface LINK 20 and is the answer not in the manual?

Heart Interface LINK 20 Specifications

General IconGeneral
BrandHeart Interface
ModelLINK 20
CategoryControl Unit
LanguageEnglish

Summary

Link 20 Introduction and Warnings

Power Connection Warnings

Critical safety instructions for connecting power to the Link 20 unit.

Important Battery Facts

Explains amp-hour ratings and deep cycle battery usage guidelines.

Link 20 Battery Management

Overcharge Amp-Hours

Details how overcharge amp-hours are displayed and their implications.

Battery Capacity Testing Methods

Using Your Inverter for Battery Capacity Testing

Explains how to use an inverter for battery capacity testing procedures.

Link 20 Setup Procedures

Factory Default Values

Lists the default settings for various monitoring and setup parameters.

Setting Up Voltage and Current Parameters

Conditions to Reset Amp-Hours to Zero

Lists the specific conditions required for the unit to reset Amp-hours to zero.

How to Set Charged Voltage

How to Set Charged Current Percentage

Setting Time Remaining Averaging Period

Introduction to Rate Compensation and Peukert's Exponent

Explains battery capacity reduction at higher discharge rates and Peukert's equation.

How to Set Up Advanced Functions

Link 20 Functions Table

A reference table listing advanced functions and their descriptions.