65
Hearth & Home Technologies • DV3732SBI, DV3732SBIL • 2215-900 • 9/09
LATCHE S
BOTH BOT TO M
AND TOP )
GLASS
ASSEMB LY
J. Air Shutter Setting
Air shutter settings should be adjusted by a qualifi ed in-
staller at the time of installation. The air shutter is set at
the factory for minimum vertical vent run. Adjust air shut-
ter for longer vertical runs.
NOTICE: If sooting occurs, provide more air by opening
the air shutter.
Figure 14.5 Fixed Glass Assembly
G. Fixed Glass Assembly
Removing Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fi xed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fi replace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Removing Fixed Glass Assembly
• Pull the four glass assembly latches out of the groove
on the glass frame. Remove glass door from the appli-
ance. See Figure 14.5.
Replacing Fixed Glass Assembly
• Replace the glass door on the appliance. Pull out and
latch the four glass assembly latches into the groove
on the glass frame.
Air Shutter Settings
H. Install Louvers and Trim
• Install optional trim kits and/or surrounds using the
instructions included with the accessory.
• Use non-combustible materials to cover the gap between
the sheet rock and the appliance (when applicable to
model).
I. Install Hood
See Figure 14.6.
Models NG LP
DV3732SBI
DV3732SBIL
1/8 in. 3/16 in.
HOOD CLIPS LOCATED ABOVE GLASS FRAME.
SEE DETAIL A.
DETAIL A
Figure 14.6 Install Hood
To Next Page
Loading...
