16
Vent-Free Gas Fireplace User’s Manual
4.
Route wire harness through channel in the back corner of the fireplace. There are two observation
ports on the back of the fireplace to assist in routing the wire harness. Before securing blower
assembly to the fireplace, put a wire clip on wire harness and snap into the inside of the fireplace
back panel. Secure blower with 8 screws (see Fig. 8).
Fig. 8—Wire Routing and Blower Attachment
Installation (cont.)
INSTALLING THE BLOWER (OPTIONAL) - continued
Fig. 9—Connecting Switch
5.
Route
the wire harness as shown through the opening
in the control panel. Connect the wires to the switch in
the order identified in the wiring diagram (see Fig. 9).
To Next Page
Loading...
