Need help?Do you have a question about the Heat Controller A-DVH12SD-0 and is the answer not in the manual?
General| Voltage | 208-230V |
|---|---|
| Refrigerant | R410A |
| Indoor Unit Noise Level | 38 dB(A) |
| Outdoor Unit Noise Level | 52 dB(A) |
| Cooling Capacity | 12000 BTU/h |
| HSPF | 9.0 |
| Power Supply | 1 Phase, 60 Hz |
| Operating Temperature (Heating) | 32°F to 86°F |
| Heating Capacity | 13, 000 BTU/h |
Instructions to prevent injury to users and property damage.
Warnings regarding installation and operation to prevent hazards.
Operational guidelines for safe use and maintenance of the unit.
Lists model numbers for indoor and outdoor units by capacity.
Specifies minimum clearances for indoor and outdoor unit installation.
Lists and illustrates various features of the mini-split system.
Provides dimensional drawings and data for the indoor unit.
Details dimensions and hole specifications for the mounting bracket.
Provides dimensional drawings and data for the outdoor unit.
Illustrates the refrigerant cycle for cooling-only models.
Illustrates the refrigerant cycle for heat pump models.
Wiring diagrams for various indoor unit models.
Wiring diagrams for various outdoor unit models.
Guidelines for electrical installation, codes, and wiring.
Table specifying pipe sizes for gas and liquid line sets.
Specifies maximum allowed lengths and elevation differences for line sets.
Instructions for field charging refrigerant based on line set length.
Defines abbreviations for temperature sensors and set points.
Explains icons and indicators on the indoor unit display board.
Details unit protection mechanisms against faults like compressor temp, fan speed, etc.
Describes the operation of the unit when only the fan is active.
Details compressor and fan operations based on temperature and AT in cooling mode.
Details compressor and fan operations based on temperature and AT in heating mode.
Covers defrosting conditions, ending, and process.
Protection mechanism for high evaporator coil temperature.
Details the auto mode selection based on temperature difference.
Covers fan speed, louver function, and compressor operation in dry mode.
Describes how to force the unit into auto or cooling mode.
Explains the timer settings for automatic unit operation.
Details the sleep mode operation and its duration.
Describes the unit's behavior after a power failure.
Explains the automatic movement of the unit's panel.
Optional feature for low-temperature heating to prevent freezing.
Lists error codes displayed by the indoor unit and their meanings.
Discusses troubleshooting for outdoor unit errors and PCB components.
Explains the meaning of LED lights on the outdoor unit's PCB.
Details error codes indicated by LED3 and LED4 on specific outdoor units.
Diagnoses and provides solutions for EEPROM parameter errors.
Diagnoses and provides solutions for communication errors between units.
Diagnoses and provides solutions for zero crossing detection errors.
Diagnoses and provides solutions for indoor fan speed control errors.
Provides resistance and voltage tests for indoor AC fan motors.
Diagnoses and provides solutions for temperature sensor open/short circuits.
Diagnoses and provides solutions for refrigerant leakage detection errors.
Diagnoses and provides solutions for IPM or IGBT protection errors.
Diagnoses and provides solutions for compressor top high-temperature protection.
Diagnoses and provides solutions for inverter compressor drive errors.
Instructions for measuring compressor winding resistance.
Tables and charts showing service port pressures for cooling mode.
Tables and charts showing service port pressures for heating mode.
To Next Page