Heath Zenith Motion Sensing 3-Way Wall Switch SL-6107 - User Manual

SL-6107
© 2006 DESA Specialty Products™ 595-4514-14
The Heath
®
/Zenith Motion Sensing 3-Way Wall Switch
automatically controls indoor lighting:
• In
AUTO mode, the control automatically turns the
light on when you enter the room. The length of time
the light stays on is adjustable.
The Heath
®
/Zenith SL-6107 Motion Sensing 3-Way
Wall Switch replaces any “3-way” switch. Perfect for
rooms or hallways where two wall switches control
a single light.
This package includes:
• light control
• wire connectors
• wire jumper
• decorative cover plate
• mounting hardware
MOTION SENSING
3-WAY WALL SWITCH
AUTO
OFF ON

Summary

INSTALLATION

Add Jumper At Remote 3-Way Switch

Connects a jumper wire between the common and switched wires for power supply.

Replace Other Switch

Details connecting the motion sensor wires to the existing wiring for replacement.

Test Common Wire Connection

Provides a flowchart to test and verify the correct common wire connection.

SPECIAL INSTALLATIONS

Single Switch Installation

Instructions for connecting the wall switch in a single switch circuit.

2 Switch Installation

Instructions for connecting motion sensors at both 3-way switches.

ADJUSTMENT

Photo Sensitivity Adjustment

Guides on setting the light level for sensor activation, from full daylight to dark.

Time Control Adjustment

Explains how to select the duration the light stays on, from 5 seconds to 20 minutes.

Install Wall Cover Plate

Secures the decorative wall plate using provided screws after installation.

OPERATIONS

Using the Light Control

Describes the three functions (Off, Auto, On) of the light control switch.

TROUBLESHOOTING

TECHNICAL SERVICE

SPECIFICATIONS

FIVE YEAR LIMITED WARRANTY

Heath Zenith Motion Sensing 3-Way Wall Switch SL-6107 Specifications