Included are:
• The sensor switch
• Cover plate
• 3 wire connectors
• 2 large screws
• 2 small screws.
INSTALLATION
SELECT A LOCATION
The sensor is more sensitive to motion across
the front of the sensor than to motion towards
the sensor.
The detector senses heat in motion and pos-
sibly heat sources that change temperature
quickly. Therefore, to avoid false triggering,
avoid placing the sensor where it will be aimed
at air conditioners, heaters, and other sources
of heat or cold.
30 ft.
(9.1 m)
Features include:
• 150° motion detection angle
• Adjustable on-time from 5 sec. to 20 min.
• Adjustable photocell
• Works with incandescent and rapid start
uorescentlighting
• Works with motors up to 1/8 hp
• Slide switch selectable OFF, ON, and AUTO modes
The SL-6105 Motion Sensor Wall Switch detects motion to turn on
lights for an adjustable amount of time. A built-in photo cell can be
set to keep lights off when the lights aren’t needed. The unit has excel-
lent sensitivity and a wide 150° detection range. It can be used with
incandescentlightingaswellasrapidstartuorescentlighting.
Installation is as easy as replacing a wall switch. However, some
codesrequireinstallationbyaqualiedelectrician.
Motion Sensor
Wall Switch
SL-6105
15 ft. (4.6 m) 0
Figure 1 - Typical Plan View of
Coverage
© 2006 DESA Specialty Products™ 595-4881-10
To Next Page
General
