Paseso
@
REPEAT
RATE
When
the REPT
(repeat)
key and any character
key are
held
down
at the same time, the character is re-
peatedly
written
on
the
screen.
The repeat rate can be
set at 3.7,
7.5,
\5, or
30
characters
per
second.
Picto-
rial 3-3 shows the
fumper
wire connection
(on
the
bottom of the keyboard circuit board) for each of the
repeat
rates.
You may want
to
try
all of the
repeat rates
to determine which one best suits
your
needs.
To
change the
repeat rate:
7.
Turn
the ON/OFF switch OFF.
2. Remove
the
bottom
panel
and set
it
aside.
3.
Pull
the
jumper
wire out of
the
connector
pin.
4, Insert the
jumper
wire into the connector
pin
that corresponds to the repeat rate
you
desire.
5.
Reinstall the bottom
panel.
CLEANING
You
can
use
any
mild household detergent and a soft
cloth to clean
the cabinet
of
the Video Terminal. Wipe
the dust
from
the
window
with
a soft
cloth.
If
smudges still remain,
clean
the window
carefully
with a mild soap and a soft cloth. Be careful
you
do
not scratch the
plastic
window.
To Next Page
Loading...