Heathkit HA-14 - HW-12, HW-22, HW-32 Transceiver Connection and Modification

#6x3/8 SHEET
METAL SCREW
RUBSER FOOT
ORT
46 FLAT WASHER
6-32x3/8 SCREW
LONG
RUBBER FOOT
[| =6 FLAT WASHER
be 32xl SCREW
PICTORIAL 17
x)
Mount
a
long
rubber
foot
on
each
front
cor-~
ner
of
the
cabinet,
Measure
in
from
the
side
and
front
of
the
cabinet
as
shown,
Secure
each
foot
with
a
6-32
x
1"
screw,
#6
flat
washer,
#6
lockwasher,
and
a
6-32
nut,
~~
Slide the chassis into the cabinet,
ior
Secure the chassis to the cabinet with #6 x
3/8" sheet metal screws,
VOTE:
The
blue
and
white
identification
label
shows
the
Model
Number
and
Production
Series
Number
of
your
kit,
Refer
to
these
numbers
in
any communications with the Heath Company;
this assures you that you will receive the most
complete and up-to-date information in return,
( ) Install the identification label in the follow-
ing manner:
1, Select a location for the label where it
can easily be seen when needed, but
will not show when the unit is in oper.
ation, This location might be on the side
of the chassis frame,
2, Carefully peel away the backing paper.
Then press the label into position,