Heathkit HA-14 - Operating the Linear Amplifier; SSB Operation Procedures; SWR Measurements and Tuning

Page 32
HBATHEIT
iti Faas eect
=
77 | | 28
Nee
INSET
{ [senew*
SCREW
SHORT
Ue RuaBeR
LINEAR AMPLIFIER
LINEAR AMPLIFIER
LINEAR AMPLIFIER
LINEAR AMPLIFIER
Figure 1
: INSTALLATION
LOCATION
The tubes in the Linear Amplifier generate
considerable heat, therefore, the unit should
be mounted in a location that will allow good
air circulation, This applies to both mobile and
fixed station installations, Three suggested
mobile installations are shown in Figure 1,
POWER SOURCE
The Linear Amplifier is designed to operate from
a 2400 V DC voltage source, This can either be
a transistorized mobile power supply or an AC
fixed station supply, Use the proper power sock-
et wired previously,