Heathkit HA-14 - Product Warranty Information

SYMPTOM
Tube filaments and
pilot lamp do not
light,
POSSIBLE CAUSE
Power plug or sockets incorrectly wired,
2
Open
circuit
breaker
in
power
supply,
3,
Tube
filaments
and
pilot
lamp
wiring
in-
correct, NOTE: Tube filaments are con-
nected in series, If one opens, neither will
light,
. No bias voltage (~120) to relay,
2, No ground between pin 12 of power socket
and exciter in keyed position,
Antenna relay will
not close when exciter
is keyed,
1, Wiring error on Meter switch,
2, Wiring error on SWR coaxial cable,
3, Shielded leads shorted,
4, Defective diodes D2 and/or D3,
No forward or reflected
power reading on Linear
Amplifier meter,
Output will not peak
on some or all bands,
1, Band switch in wrong position,
2, 80-40-20 meter final coil incorrectly mount-
ed and wired,
Tubular capacitors interchanged,
All power to Linear
Amplifier turns off in
mobile operation,
. Overdriving from exciter,
2, The microphone level setting on the exciter
is too high,
3, Defective 40 ampere circuit breaker in
power supply,
In mobile operation,
antenna relay keeps
dropping out on voice
peaks,
The microphone level setting on the exciter
is too high,
2. No ALC voltage being applied back to the
exciter,
3. Exciter ALC circuit not operating,
4,
Corroded
battery
connections
causing
a
high
resistance connection,
Page 37