START.
NOTE: When you install a diode, always match
the band on the diode with the band mark on the
circuit board. A DIODEWILLNOT WORKIF IT
ISINSTALLEDBACKWARDS.SeeDetaill-1A.
<;iH\m'i;)A~~JD
Dl:
lN4149
diode #56-56).
(tI)
Solder the leads to the foil and cut off the
excess lead lengths.
Page 13
IMPORTANT: TRE BANDED ERD OF DIDOES
C~R
BE MARKED IN A NUMBER OF
W~YS.
,~
v
Prepare a 2-1/2" black wire. Connect this
wire between the two
"H"
holes as
shown.
(~'" R7: 10 kD.(brown-black-orange).
R6: 56 kD.(green-blue-orange).
(...(' Solder the leads to the foil and cut off the
excess lead lengths.
To Next Page
Loading...
