voltages to the circuits of integrated circuit
01.
If the Converter is plugged
into jack
J1,
power is taken only from the Converter Charger, the battery, if
installed, is disconnected from the circuit. NOTE: The Converter will not
charge the battery in your Wattmeter even if you use a rechargeable battery.
The Wattmeter may be powered at all times with the Converter; however, if
you wish to operate the instrument away from an AC source, you must use a
battery.
\rilen be rrm::tpcnel Sensiti\'ity control is rotated fully counterclockwise
lint!
be cu:J:oo:c::cks. the battery (or Converter) power, through contacts
il:
be
?.:.:'-.-\i,'G
o'...-itcb (which must be in the AVG position), may be
oboe!'.-ed
CL::::e
3.-\IT
portion ofthe FWD meter. NOTE: Ifyou have turned
be 5e'lSi:i'.-:'::-'C02t:rc:)]to check the battery condition, be sure to once again
"Set""
,::e
:I":::=-
::::Ie:er :0 meaSille SWR.
~fPORT.~~";
'-\:"''-'':'-0
re:-.leuthe PEP-AVG switch to the AVG (out) posi-
tion wne:J
::=''2::"
',1e:er io
::0,
in use: this disconnects the battery from the
circuit.
To Next Page
Loading...
