Heathkit HR-10B - Harness Wiring

I~
240 VAC Wiring
Refer to Detail 2A for the following step.s,
( ) Cut the blackcgreen lead to the same
length as the black-yellow lead, Then twist
these leads together loosely and connect
both to lug 1 of terminal strip BC {S-2).
( ) Connect
the black lead to lug 4 of control FB
{S-1).
( ) Connect
the black-red lead to lug 2 of ter-
minal strip BC (NS).
HARNESS WIRING
NOTE: In the following steps, the harness break-
out points will be referred to with the letters
BO.
( )
Locate the wiring harness and form it as
shown in Detail 2B,
GREEN
WHITE: .
Detail 2B
6"
Page 17
Connect
the harness leads exte.tding from BO 12
as follows:
( ) Connect
the brown harness lead to lug 4 of
~ · tube socket V1 (NS).
( ) Connect the yellow· harness lead to lug 1 of
d ter.minal strip R {NS),
( ), Connect the blue harness lead to lug 2 of
./ terminal strip S (NS), .
(
)'Connect both red harness leads to lug.4 of
/ terminal strip R {NS), .
Connect
the leads extending from BO 11 as fol-
lows:
(
)'Connect both red harness leads to lug 2 of
/ terminal strip Q (NS).
( A- Connect both brown harness leads to lug 4
_/ of tube socket V2 (NS). .
Connect
the harness leads extending froll) BO 10
as follows:
(
),. Connect the orange harness lead to lug 2 of·
/
octal socket CC (NS).
Y
Connect both brown harness leads to lug 3
of
octal socket CC (NS).
(_),.Connect both red harness leads to lug 4 of
/
octal socket CC (NS).
Connect the
harness leads extending from BO 9
as follows:
( ) Connect both red harness leads to lug 3 of
_:../'control BE (S-2).
yconnect the white harness lead to lug 2 of
control BE (S-1 ).
Connect the harness \eads extending from BO 5
as follows: :
( ..} Connect
the greeh harness lead to lug 6 of
-~ · octal socket BD (S-1).
(
), Connect the black harness lead to lug 4 of
/
terminal strip BC (NS),
Connect the harness leads extending from BO 6
as follows:
J ) Connect both blue harness leads to lug 1
of terminal strip L (NS).
Place ~e ':'irin~ harness on the chassis as ( ) Connect both red harness leads to lug 3
shown m PlCtonal 2. ~ of terminal strip L (NS).
( ) Place the four leads at BO 13 through
grommet HG. They will be connected later.
j.--1 Connect the three brown harness leads to
lug 3 of tube socket V3 (S-3).