Need help?Do you have a question about the Heathkit HR-10B and is the answer not in the manual?
General| IF | 455 kHz |
|---|---|
| Image Rejection | 40 dB |
| Tuning | Continuous with bandspread |
| Modes | CW |
| Sensitivity | 1 uV for 10 dB S+N/N |
| Power Supply | 117 VAC 50/60 Hz |
| Dimensions | 15" W |
Amplifies incoming RF signal and mixes it with oscillator frequency.
Amplifies intermediate frequency signal and filters it for selectivity.
Detects audio signal and amplifies it for speaker output.
Rectifies and filters AC voltage to provide DC power.
Instructions for mounting various components and hardware onto the chassis.
Connects the power and audio output transformer leads according to wiring diagrams.
Connects various wires from the wiring harness to specific terminals and sockets.
Installs resistors, capacitors, and other electronic components onto the circuit board.
Adjusts IF transformers and the meter for proper signal reception.
Aligns the front end assembly for optimum radio frequency reception.
A chart detailing alignment frequencies and adjustments for each band.
Installs labels, covers, and describes control functions for operation.
Explains the function of each front panel control.
Provides settings for operating the receiver in AM mode.
Provides settings for operating the receiver in CW mode.
Provides settings for operating the receiver in SSB mode.
Information on how to order replacement parts and the process for returns.
To Next Page
