NUTS
AND
WASHERS
INCLUDED WITH
METER.
SOLDER
LUGS
INCLUDED WITH
METE
R.
Detail 13E
NOTE: When you remove the meter from its carton,
use
care
to
avoid pulling off
the
front cover of
the
meter.
( ) Refer
to
Detail13E and mount the meter
at
location
B.
Use
the
hardware included in the meter
box
"Do
not
overtighten the mounting
nuts
or you could damage
the
meter case.
( ) Remove the shorting wire from betweeen the meter
terminals and discard it.
( )
Position the solder lugs toward the
bottom
of
the
instrument and bend them
out
from the back of the
meter as shown in Detail 13E.
( ) Install a rocker switch
(#60-24) at location H using
two 6-32 x
7/8"
phillips head screws, two
1/2"
spacers
and one
#6
solder lug in
the
order shown in Detail
13F.
Position
the
switch
so
that
its lower lug
is
closer
to
the edge
of
the front panel
than
to
the panel center.
Detail 13F
( ) Repeat this procedure for another rocker switch to be
installed at location G. Do not use a solder lug at this
location.
NOTE: Control hardware,
in
the following four steps,
consists
of
a control lockwasher, a control flat washer, and a
control nut.
Place the control hardware as shown in Detail
13G and position
the
controls and switches
as
shown in
Pictorial 13.
Detail13G
CONTROL
LOCKWASHER
DU
AL
CONTROL
To Next Page
Loading...
