Need help?Do you have a question about the Heathkit IG-18 and is the answer not in the manual?
General| Output Waveform | Sine Wave |
|---|---|
| Output Impedance | 600 Ohms |
| Type | Signal Generator |
| Distortion | Less than 1% |
| Power Requirements | 120 VAC, 60 Hz, 10 Watts |
Detailed steps for assembling the wave generator circuit board.
Instructions for mounting and assembling the power supply circuit board.
Instructions for assembling front and rear panels.
Steps for assembling the main unit components.
Wiring instructions for the top chassis.
Wiring instructions for the bottom chassis.
Instructions for installing front panel knobs.
Procedures for testing the assembled unit's functionality.
Procedures for calibrating and adjusting the unit.
Table listing problems and potential causes/solutions.
Description of the sine wave generation circuitry.
Description of the square wave generation circuitry.
To Next Page
