Heathkit IG-18 - Front and Rear Panel Subassemblies

Page 24
PART PARTS DESCRIPTION
No.
Per Kit
Other Hardware
(26)252-7 5
(27)253-10 6
(28)254-4 6
(29)252-32 1
(30)427-3 5
Control nut
Control flat washer
Control lockwasher
Speednut
Binding post base
METAL PARTS-HANDLE
(31)90-401-2 2
100-769 1
100-770 1
(32) 100-771 2
(33)204-759-1 4
(34)210-35 1
(35)211-32 2
WIRE
Hookup Wire
344-50 1
344-51 1
344-54 1
344-55 1
344-57 1
344-58 1
Cabinet half shell
Front panel
Rear panel
Side rail
End cap
Bezel
Handle
Yellow
Green
Violet
Gray
PART PARTS DESCRIPTION
No.
Per Kit
Other Wire
89-23 1
341-1 1
341-2 1
Line cord
Black test lead
Red test lead
BUSHINGS
2
MISCELLANEOUS
{42)253-85
(43}260-16
407-131
(44)412-15
(45)431-41
(46)431-35
(47)432-27
{48}438-13
(49)259-20
(50)421-22
2
2
1
1
1
1
1
2
4
1
knob bushing
shaft knob bushing
shaft knob bushing
knob
shaft knob
shaft knob
Felt washer
Alligator
Meter
Neon lamp
2-lug terminal strip
7 -lug terminal strip
Line cord adapter
Banana plug
Solder pin
Fuse, 3/4 ampere slow blow
STEP-BY-STEP ASSEMBLY
FRONT AND REAR PANEL SUBASSEMBLIES
Refer to Pictorial 13 for the following steps.
( ) Place a soft cloth on your work surface
to protect the front panel from being
scratched in the following steps. Then posi-
tion the front panel as shown.
Mount the pilot lamp lens at A as shown in
Detail 13A. The lens should be tight against
the front of the panel and thespeednut
pressed down tightly.
NOTE: When you install the binding post bases
in the following steps, be sure the hole through
each binding post base is in a horizontal po-
sition.
Detail 13A