Heathkit IG-18 - Unit Assembly

@
@
@
Page 25
PICTORIAL 13
( ) Refer to Detail 13B and install a binding
post base at J. Use two binding post base
insulators, a #6 lockwasher, a #6 solder lug,
and two
6- 32 nuts. Be sure the binding post
insulators are seated within the mounting
hole.
Position the solder lug as shown in
Pictorial 13.
~b~~1~2p 11\
BINDING ~
POST BASE ~
J
BINDING.
POST BASE
INS u L.~~OR .. Jsir:R~y£~ r F
BIND I ~t:.::>
POST BASE ~
INSULATOR ~
#6 LOCKWASHER ~
6-32 NUT @
#6 SOLDER LUG~
6-32 NUT ~-
Detail 138
In a like manner, install binding posts at
locations K, N, and p.
Refer to Detail 13C and install the ground
binding post at location R. Use a binding post
base, one insulator, an external-internal
lockwasher and a 6- 32 nut.
Install red binding post caps at locations J
and N.
( ) Install black binding post caps at locations
K and p.
( ) Install the green binding post cap at location
R.
NOTE: The following step is optional, and is in-
tended to prevent the removal and loss of the
binding post caps.
( ) Refer to Detail 13D and tap the handle of a
phillips screwdriver with a hammer to en-
large the open end of each binding post.
BINDING POST CAP
BINDING POST BASE
BINDING POST
BASE INSULATOR ~
i: 2:; 1: N El ,{,;,tftl'[r)i:>
EXTERNAL-INTERNAL~'
LOCK WASHER ,~,
6-32 NUT
Detail 13C
Detail 130