Heathkit IG-18 - Page 40

Page 34
240 VAC Wiring
Refer to Detail 18C for the following steps.
( ) Remove the insulation from a 1" length of
hookup
wire.
( ) Connect a 1" bare wire from lug 2 (S-2) to
lug 3
(S-l) of the power transformer.
Solder transformer lug 1 (S-l).
) Solder transformer lug 4 (S-2).
240 VAC WIRING
Detail l8C
BACK OF REAR PANEL
.~~~i-
.:.:::.~~
1. PULL SLACK OUT OF CORD.
2. CR IMP STRAI N RELI Ef ON CORD ABOUT
ONE INCH FROM REAR PANEL.
3. COMPRESS STRAIN RELIEF SO THAT IT WILL
PASS INTO
HOLE IN REAR PANEL. LINE-UP
FLATS ON STRAIN RELIEF WITH STRAIGHT SIDES
Of HOLE.
4. PULL LINE CORD ON INSIDE OF INSTRUMENT TO
EXPAND STRAIN RELIEF .
.... ------Detail 180 ----- .....
NOTE: In the following step, if you have used
the flat 3-lead line cord supplied with this kit,
install strain relief #75-71. If you have used a
round line cord (not supplied with this kit),
install strain relief #75-30.
( )
Refer to Detail 18D and install the line cord
strain relief on the line cord.
This completes the wiring of your Heathkit Sine-
Square Audio Generator. Carefully inspect all
solder joints for unsoldered wires or loose con-
nections. Remove any wire clippings or solder
splashes that may be lodged in the Wiring. Then
proceed to the Knob Installation section.