Heathkit IO-4205 - Step-By-Step Assembly

Page 36
STEP-BY-STEP ASSEMBLY
The steps performed in this Pictorial are
in this area of
the circuit board. ------¥.4"
START•
Position the circuit board printed side
up as shown .
NOTE: When you install a diode, al-
ways match
the band on the diode with
the band on the circuit board .
201: 1N4149
diode (#56-56).
0214 : 1N4149 diode (#56-56).
1" bare wire.
1" bare wire.
J) 1" bare wire.
( /1 1-3/8" Brn wire.
t- ) Solder the leads to the foil and cut
off the excess lead lengths.
1" bare wire.
"bare wire.
1" bare wire.
1-1/8" Brn wire.
1-5/8" Brn wire.
1-1/8"
Brn wire .
Solder
the leads to the foil and cut
off the excess lead lengths .
(INCHES)
2
II II I iII 'i I I I
, I I ,
I I
Q . !5 1 (CM ) 2
3 •
I
e
I ~~
I I I
I I
e
PICTORIAL 2-1
3
I I
7 8
I I I
I I
9
4
I I
I
10 11
IDENTIFICATION
DRAWING
PART
NUMBER
1-1/8"
Brn
wire .
1-3/4" Brn wire.
1-5/8" Brn wire.
1-3/8" Brn wire.
Solder
the leads to the foil and cut
off the excess lead lengths.
1-7/8" Brn wire.
1-1/4" Brn wire.
1-1/2" Brn wire.
2" Brn wire.
Solder
the leads to the foil and cut
off the excess lead lengths .
5
I I I I. I I I. I I I I
I I 1 I
12 13 14
6
I I
I
"'
I I
I
17
7
I