Heathkit IO-4205 - Step-By-Step Assembly

Page 61
STEP-BY-STEP ASSEMBLY
Refer to Pictorial4-1 (Illustration Booklet, Page 11) for
the following
steps .
)
Position the chassis as shown. This is the top
side of the chassis. The front of the chassis is to
ymn left.
( / ) ~ fer to Detail4-1A and install a plastic grom-
met in hole BA from the top of the chassis.
POSITION THE SMALL
PORTION OF THE GROMMET
INTO THE SHASSIS HOLE.
BEND THE LARGE PORTION
OF THE GROMMET OVER AND
INTO THE SMALL PORTION .
PRESS IT FIRMLY INTO
PLACE.
Detail 4-1A
In the same manner, install plastic grommets in the
following chassis holes.
( ~
c /
B/
NOTE: Use the flat head screws only when flat head
hardware is specifically called for in a step.
ft 6-32 X 3/16"
@ SCREW
Detail 4-1B
( ~ Refer to Detail 4-1B and mount a #6 solder lug
on top of the chassis at location K with a 6-32 x
3/16"
screw and a 6-32 nut. Position the solder
lug as shown .
(/ Refer
to Detail4-1C and mount a #6 solder lug
on the bottom of the chassis at location N with a
6-32 x 3/16"
screw and a 6-32 nut. Position the
solder lug as shown.
In the same manner, install a #6 solder lug at
location P.
'f 6-32 X 3/16"
SCREW
I
, c;o!f:i\iffl,lflf~ !':,o :;~~~ ~F
I
Detail 4-1C