Heathkit IO-4205 - Page 69

~ H ~ f
\
POWER SUPPLY
CIRCUIT BOARD
6- 32 X 3 /16 "
'T
<ID
~~~~--------~
J
()
~
@
Page 67
[01,
~
0
I
~
'
@
\QJ
f) ()
PICTORIAL 4-6
Connect the wires coming from B0#6 of the harness
to the power supply circuit board as follows:
Large Blk
wire to hole AE (S-1).
Large Org
wire to hole X (S-1).
Large Red
wire to hole W (S-1).
Large Yel
wire to hole AF (S-1).
Refer to Pictorial 4-6 for
the following steps .
Connect
the leads coming from the transformer T1 to
the
po er supply circuit board as follows:
(y Large
Wht-Yellead to hole AB (S-1).
( ) Either large
Yellead to hole E (S-1).
( ~ Other large Yellead to hole C (S-1) .
(
~ arge Wht-Brn lead to hole I (S-1) .
(V ) Large Wht lead to hole H (S-1).
( ~ Either large Red lead to hole F (S-1).
/.
( Other large Red lead to hole G (S-1).
( ~ Either large Brn lead to hole A (S-1) .
(
/o ther large Brn lead to hole B (S-1).
l-L/ / -z.c ~
This complete S'me wiring to the po~er supply circuit
board. Be sure all connections are soldered , and cut
off all excess lead lengths as close to the foil as possi-
ble. ~
Temporarily mount the power supply circuit
board at hex studs CL and CH with 6-32 x 3/16"
screws.