Heatilator BCBV36 - User Guide; 2 Operating Instructions; Gas Fireplace Safety; Your Fireplace

Heatilator • BCBV36 • 4008-033 • Rev P • 8/12 7
2
Operating Instructions
Glass Doors
(not shown)
Section 2.E.
Outside Air Kit
Mantel
Hearth
(not required)
Clear Space
Section 2.D.
High Limit Switch
Circulating Air
Passageways
Outside Air Kit
Handle
Closed
Open
Grate
Figure 2.1 General Operating Parts
B. Your Fireplace
WARNING!DONOToperatereplacebeforereading
andunderstandingoperatinginstructions.Failure
to operate  replace according to operating instructions
could cause  re or injury.
If you expect that small children or vulnerable adults may
come into contact with this  replace, the following precau-
tions are recommended:
• Install a physical barrier such as:
- A decorative  rescreen.
- Adjustable safety gate.
• Install a switch lock or a wall/remote control with child
protection lockout feature.
• Keep remote controls out of reach of children.
A. Gas Fireplace Safety
WARNING
HOT SURFACES!
Glass and other surfaces are hot during
operation AND cool down.
Hot glass will cause burns.
• DO NOT touch glass until it is cooled
• NEVER allow children to touch glass
• Keep children away
• CAREFULLY SUPERVISE children in same room as
 replace.
• Alert children and adults to hazards of high temperatures.
High temperatures may ignite clothing or other fl ammable
materials.
• Keep clothing, furniture, draperies and other  ammable
materials away.
• Never leave children alone near a hot  replace, whether
operating or cooling down.
• Teach children to NEVER touch the  replace.
• Consider not using the  replace when children will be
present.
Contact your dealer for more information, or visit: www.
hpba.org/staysafe.
To prevent unintended operation when not using your
 replace for an extended period of time (summer months,
vacation, trips, etc):
• Remove batteries from remote controls.
• Turn off wall controls.
• Unplug 3 volt adapter plug and remove batteries on IPI
models.
• Turn off gas controls valve on standing pilot models.
When lighting the pilot light on  replaces with a stand-
ing pilot, check for the presence of residual gas build-up.
See Standing Pilot Lighting instructions and Maintenance
Tasks.
User Guide