Heatilator BCBV36 - Clear Space; Decorative Doors and Fronts; Remote Controls, Wall Controls and Wall Switches; Outside Air (Optional)

Heatilator • BCBV36 • 4008-033 • Rev P • 8/128
Clear space 3 ft (914 mm)
in front of appliance
C. Clear Space
WARNING!DONOTplacecombustibleobjectsin
frontofthereplaceorblocklouvers.High tempera-
tures may start a re. See Figure 2.2.
Avoid placing candles and other heat-sensitive objects on
mantel or hearth. Heat may damage these objects.
Figure 2.2 Clear Space
F. Outside Air (optional)
The outside air kit supplies some fresh combustion air for
your replace. It may help reduce the effects of negative
air pressure. (See Section 9.A.)
• Refer to Figure 2.1 for location of control.
• Close the inlet to prevent cold drafts when the replace
is not being used.
CAUTION!RiskofBurns!The outside air control handle
is HOT when replace is in operation. Adjust BEFORE
lighting re.
D. Decorative Doors and Fronts
WARNING!RiskofFire!Install ONLY doors or fronts
approved by Hearth & Home Technologies. Unapproved
doors or fronts may cause replace to overheat.
For more information refer to the instructions supplied
with your decorative door or front.
E. Remote Controls, Wall Controls and Wall
Switches
Follow the instructions supplied with the control installed
to operate your replace:
For safety:
• Install a switch lock or a wall/remote control with child
protection lockout feature.
• Keep remote controls out of reach of children.
See your dealer if you have questions.
G. Before Lighting Fireplace
Before operating this replace for the rst time, have a
qualied service technician:
• Verify all shipping materials have been removed from
inside and/or underneath the rebox.
• Review proper placement of logs, ember material and/or
other decorative materials.
• Check the wiring.
• Check the air shutter adjustment.
• Ensure that there are no gas leaks.
• Determine if this replace has a standing pilot or an
Intellire ignition system. Ask your dealer or open control
access panel, look at gas valve assembly.
- A standing pilot ignition will have a red or black ignitor
button (refer to Figure 12.1).
- An Intellire ignition system will not have a button.
Figure 2.3 Ignitor Button
Red Button