25 / 48
PL
SK
DE
EN
CS
HU
BEFORE STARTING THE ENGINE
FUEL
CAUTION! A
Due to transport, the machine is supplied without engine oil and fuel. For the same
reason, some types of machines are also not filled with gear oil. Before commissioning,
fill with oil and fuel!
THE ENGINE IS CERTIFIED FOR UNLEADED PETROL
Use clean, fresh, unleaded fuel of merchantable quality;
Note: I
The machine is equipped with a four-stroke engine and must be operated exclusively
with pure petrol WITHOUT oil!
WARNING! B
Petrol is highly flammable and explosive, as well as its fumes. You can be seriously
burned or injured while refilling with petrol.
FUELING
WARNING! B
Turn off the engine. Never remove the fuel cap or add fuel when the engine is
running or is hot. After stopping the engine, wait until the engine and the exhaust
components cool down completely.
1. Remove the fuel filler cap (fig. 13A).
2. Fill petrol to maximum of one cm below the lower edge of the neck.
3. Don’t overfill! Before starting the engine, wipe the spilled petrol.
4. All closures of the tank and bulk containers needs to be refitted and tightened.
CAUTION! A
Never refill the petrol in a room.
• Don’t smoke or use an open flame during refilling.
• Make sure you are away from heat, sparks and flames.
• If petrol is spilled, don’t start the engine. Immediately clean up the spilled petrol. Move the
machine from the area, where the petrol has been spilled and wait until the fuel vapours
dissipate to avoid the possibility of fire.
• Don’t use petrol containing ethanol. Don’t mix oil with petrol. For engine protection, we
recommend using a fuel stabiliser, which is available at filling stations.
• Make sure that water and dirt doesn’t get into the fuel tank.
• Fuel must not be older than 14 days.
To Next Page
Loading...
