31 / 48
PL
SK
DE
EN
CS
HU
WARNING! B
Prior to any work on the machine (maintenance, inspection, replacement of
accessories, servicing) or before storing it, ALWAYS SWITCH THE ENGINE OFF, wait
for all moving parts to stop and allow the machine to cool down. Prevent the engine
from being started accidentally. Disconnect the spark plug (disconnect the power
unit from the mains). If the machine is equipped with a trigger key, remove it.
THIS WARNING IS NOT REPEATED IN ANY FOLLOWING POINTS!
Keep this recommendation about checks, maintenance and intervals stated in this users guide.
Others service operations, which are more complicated, or it needs special tools, let it on our
authorized service.
The instructions in this manual apply under normal operating conditions. If you operate
your engine under severe conditions, such as permanent high load, high temperature
or unusually large humidity or dust, contact your service on the recommendations
applicable to your individual needs and the way of using the machine in your case.
MACHINE MAINTENANCE
• Keep the machine in good condition.
• Careful handling and regular cleaning ensure that the machine remains functional and
efficient for a long time.
• In case of abnormal vibrations proceed according to instructions (see instruction for removal
of fault).
• Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition.
• Always ensure that the ventilation openings are kept clear of debris.
• Replace worn or damaged parts for safety. Use only original spare parts.
• Replace safety and instruction stickers and labels with new if necessary.
• Frequently check the collection basket for wear or damage.
• Always be careful when adjusting the machine to avoid jamming fingers between moving
blades and rigid machine parts.
• Regularly check the blade for damage.
CLEANING
CAUTION! A
Do not hose engine. Water can damage engine or contaminate the fuel system.
• If the engine has been running, allow it to cool for at least half an hour before cleaning.
• After use, clean the outside of the machine, empty the grass-catcher and shake it to remove
grass and other debris.
• Clean the mower thoroughly from grass and dirt after each mowing. Clean particularly
the area under the chassis around the blade, the ejection tunnel to the grass bag, and
the space around the gearbox on the rear wheel axle (only for self-propelled mowers). Make
sure that the blade or its carrier is not damaged. Also, visually check that the V-belt cover in
the area above the blade is not loosened or otherwise damaged.
To Next Page
Loading...
