32 / 48
PL
SK
DE
EN
CS
HU
• Clean under deck by tilting the machine so that the spark plug is always up.
• Wipe the surface of the machine and engine cover with dry cloth. Clean the cover of
the machine, especially the ventilation holes.
• Do not let the handles contaminate with oil or grease. Clean the handle clean with a damp
cloth washed in soapy water.
• Do not use solvents or petrol! This can cause irreparable damage to the product. The plastic
parts can be eaten away by chemicals.
• Clean wheels, coat of grass can change the height of cut.
• If any of the parts of the machine is cleaned by water or a damp cloth, etc., it must be
completely dry. Then the metal parts must be grease against the corrosion with suitable
protective oil. Make sure that the water doesn´t leak into the internal parts of the machine.
• If there is a connection to a garden hose on part of the machine, it is possible this part wash
by water. Then it is necessary the whole washed part of the machine and places where
the water were sprayed when cleaning, completely dry and grease agains the corrosion with
suitable protective oil.
• We do not recommend washing the machines with pressure washer.
• Potential damage of the parts due to corrosion, can not be assessed as a manufacturing or
material defect.
C Always empty the grass-catcher and do not leave containers full of cut grass inside
a room.
C Never use aggressive detergents or solvents for cleaning.
LUBRICATION INSTRUCTIONS
• Lubricate the ball bearings (if equipped) in each wheel at least once a season with a light oil.
• Lubricate the pivot points on the blade control handle and the brake cable at least once
a season with light oil. The blade control must operate freely in both directions.
CUTTING BLADE
CAUTION! A
Protect hands by using heavy gloves or a rag to grasp the cutting blades.
Tip mower with the spark plug up (the handle down). Remove the hex bolt and washer which
hold the blade and blade adapter to the engine crankshaft. Remove the blade and adapter from
the crankshaft (fig. 19). Bolt has a typical right-hand thread.
CAUTION! A
Periodically inspect the blade adapter for cracks, especially if you strike a foreign
object. Replace when necessary and check the machine overall.
• For best results your blade should be sharp. The blade may be resharpened by removing
it and either grinding or filing the cutting edge keeping as close to the original bevel as
possible. It is extremely important that each cutting edge receives an equal amount of
grinding to prevent an unbalanced blade. Improper blade balance will result in excessive
vibration causing eventual damage to the engine. The blade can be tested for balance
To Next Page
Loading...
