EasyManua.ls Logo

hecht 9254 - Engine Pre-Operation Check; Operation

hecht 9254
44 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
27 / 44
PL
SK
DE
EN
CS
HU
If petrol is spilled, don’t start the engine. Immediately clean up the spilled petrol. Move
the machine from the area, where the petrol has been spilled and wait until the fuel vapours
dissipate to avoid the possibility of fire.
Don’t use petrol containing ethanol.
For engine protection, we recommend using a fuel stabiliser, which is available at filling
stations.
Make sure that water and dirt doesn’t get into the fuel tank.
Fuel must not be older than 14 days.
Note: I
Fuel can damage paint and some types of plastics. When topping up the fuel tank,
be careful and try not spill any petrol. Damage due to spillage of petrol is considered to be
due to improper use.
ENGINE PRE-OPERATION CHECK
For your safety, and to maximize the service life of your equipment, it is very important to take
a few moments to check the engine condition before operating. If you have some doubts, don´t
start the machine. Contact our authorized service.
ALWAYS CHECK THE FOLLOWING ITEMS BEFORE YOU START THE ENGINE:
Total control: Make sure there are no leaks, find loose or damaged parts the equipment powered
engine.
- fuel level
- oil levels (engine, gear, loss lubrication, according to the machine)
- air cleaner (if equipped)
- correct fitting of spark plug end.
- cleanness of controls (switches, handles)
- safety and protective equipment
- device, engine-powered tool.
CAUTION! A
Be sure to take care of any problem you find, or have authorized service dealer to
correct it, before you operate the engine. Improper maintenance to this engine, or
failure to correct a problem before operation, can cause malfunction in which you
can be seriously hurt or killed.
HIGHER ALTITUDES
The engines operating at high altitudes (above 1600 meters above sea level) require the special
attention, because decrease of the fuel mixture saturation ratio to supersaturation. This
leads to the power loss and higher fuel consumption. For more information, contact an
authorized service center.
OPERATION
The instructions in this manual apply under normal operating conditions. If you operate
your engine under severe conditions, such as permanent high load, high temperature
or unusually large humidity or dust, contact your service on the recommendations
applicable to your individual needs and the way of using the machine in your case.

Related product manuals