34 / 44
PL
SK
DE
EN
CS
HU
ENGINE ADJUSTMENTS
CAUTION! A
Do not change in any way the rated speed of the engine (carburetor side or regulator
side).
Your engine was adjusted in the factory. If the motor settings is changed in any way, the warranty
will be cancelled. If additional adjustment is necessary (eg. for high altitude), contact authorized
service center!
CLEANING
CAUTION! A
Do not hose engine. Water can damage engine or contaminate the fuel system.
• Carefully clean the machine after each use.
• If the engine has been running, allow it to cool for at least half an hour before cleaning.
• Clean all exterior surfaces.
• Wipe the surface of the machine and engine cover with dry cloth.
• Never use aggressive detergents or solvents for cleaning.
• If any of the parts of the machine is cleaned by water or a damp cloth, etc., it must be
completely dry.
• Potential damage of the parts due to corrosion, can not be assessed as a manufacturing or
material defect.
• Wipe the surface of the machine and the motor with a dry cloth.
• Touch up any damaged paint, and coat other areas that may rust with a light film of oil.
STORAGE
CLEAN THE MACHINE BEFORE STORING ACCORDING TO THE PARAGRAPH
MAINTENANCE / CLEANING.
CAUTION! A
Store this machine on place where the fuel vapors can not be in reach of open fire or
sparks. Let the fuel to run dry before long storage. Always let the machine get cool
before storing.
• Store the machine in a dry, clean and frost-protected place, out of reach of unauthorized
persons.
• Replace worn or damaged parts for safety. Use only original spare parts.
• If possible, avoid storage areas with high humidity, because that promotes rust and corrosion.
• If there is gasoline in the fuel tank, leave the fuel valve in OFF position (if the machine is
equipped with it).
• Keep the engine level in storage. Tilting can cause fuel or oil leakage.
• With the engine and exhaust system cool, cover the engine to keep out dust. A hot engine
and exhaust system can ignite or melt some materials.
• Do not use sheet plastic as a dust cover. A nonporous cover will trap moisture around
the engine, promoting rust and corrosion.
To Next Page
Loading...
