TECHNICAL SPECIFICATIONS
H1 Integrated Amplifier
Power output 120W + 120W at 8 Ohms
Minimum load Loudspeaker impedance down to 2 ohms can be used.
Input Sources 6 remote controllable inputs switched by gold plated relays
Input Terminals Gold plated Phono / RCA unbalanced and gold plated XLR balanced
Output Terminals One set of gold plated speaker terminals each channel
Line level Outputs Gold plated Phono / RCA unbalanced tape out, Preout 1 and Preout 2
Frequency response Less than +/- 0.1 dB deviation 20Hz-20kHz
Phase response Less than 2 degrees deviation 20Hz-20kHz
Signal-to-noise ratio More than 100dB
Crosstalk Less than -100dB
Distortion Less than 0.004% @ 50W 8 Ohms 1kHz
Intermodulation Less than 0.01% (19kHz + 20kHz)
Damping factor More than 1000 ( main power output stage )
Remote Control Philips RC-5 compatible IR system 36kHz modulation
Dimensions 8cm x 43cm x 45cm (HxWxD), 15kg shipment weight.
NOTE & WARNING
Hegel products should only be opened or serviced by certified technicians. The devices contain
electronic components that can cause severe electric shock. Work performed on Hegel products by
unqualified personnel can cause serious damage and personal injury.
Opening of the product by non-authorized personnel will void the guarantee.
The products must not be exposed to rain or moisture.
GUARANTEE
All Hegel products come with a 2-year guarantee against defective materials and workmanship.
In case you should need any assistance with your Hegel product please find your nearest dealer or
distributor by looking at the Hegel web site http:\\www.hegel.com
If you should have any problems locating your dealer or distributor please e-mail to info@hegel.com
www.hegel.com info@hegel.com
To Previous Page
