Need help?Do you have a question about the Hegel H1 and is the answer not in the manual?
Power| power output | 120W + 120W at 8 Ohms |
|---|---|
| minimum load loudspeaker impedance | 2 ohms |
| damping factor | More than 1000 ( main power output stage ) |
Audio Performance| frequency response | Less than +/- 0.1 dB deviation 20Hz-20kHz |
|---|---|
| phase response | Less than 2 degrees deviation 20Hz-20kHz |
| signal-to-noise ratio | More than 100dB |
| crosstalk | Less than -100dB |
| distortion | Less than 0.004% @ 50W 8 Ohms 1kHz |
| intermodulation | Less than 0.01% (19kHz + 20kHz) |
Connectivity| input sources | 6 remote controllable inputs switched by gold plated relays |
|---|---|
| input terminals | Gold plated Phono / RCA unbalanced and gold plated XLR balanced |
| output terminals | One set of gold plated speaker terminals each channel |
| line level outputs | Gold plated Phono / RCA unbalanced tape out, Preout 1 and Preout 2 |
Weight and Dimensions| dimensions | 8cm x 43cm x 45cm (HxWxD) |
|---|---|
| shipment weight | 15kg |
Explains the front panel controls, power indicator, and input selection lights.
Lists various RCA and XLR signal input connectors for different sources.
Details the Tape output, Pre outputs, and Speaker output terminals.
Explains how the RC2 controls volume, input source, and mute functions.
Advises on placing the amplifier on a flat surface for proper cooling and air circulation.
Lists technical data like power output, impedance, frequency response, and dimensions.
To Next Page
