HEIDELBERG Suprasetter 106 User Manual

ABC Operation
Suprasetter 74/105 – Operation 3–9
Removing a Printing Plate
After imaging, the printing plate will be ready for
unloading above the insertion table.
Note: You will hear a beep approx. 3 seconds before an
imaged plate appears. In addition, the middle LEDs
flash synchronously.
When the plate is output, you will hear a brief beep
again, indicating that the plate can now be removed.
Warning: Plate edges can be sharp. Failure to wear
protective gloves can result in injuries to your hands.
1. Put on protective gloves.
2. Remove the printing plate from the device for further
processing.
2
3

HEIDELBERG Suprasetter 106 Specifications

General

Resolution	2400 dpi
Plate Thickness	0.15 - 0.30 mm
Laser Wavelength	830 nm
Interface	Ethernet
Automation	Fully automated
Type	Computer-to-plate (CTP) printer
Laser Type	Laser diodes