50
Driven tool
Overview
The driven tool is used for drilling and tapping holes as well as for
milling in M19 or C-axis operation. Programs for the driven tool can
be input in manual operation, via cycles with smart.Turn or in the
DIN editor.
Display and
programming
Speed of the driven tool:
•
Constant shaft speed: 1 to 99 999 rpm
•
Constant surface speed: 1 to 9 999 m/min
Spindle speed limi-
tation
•
The MANUALplus 620 monitors the actual speed.
•
Speed limiting can be adjusted via parameter and in the feed-
rate/spindle/tool menu (TSF menu).
Spindle
synchronism
(option 131)
The spindle synchronism option is necessary for special
operations with a driven tool (e.g. polygonal turning.) This option is
included in the Opposing Spindle option.
To Next Page
Loading...
