56
Commissioning and diagnostic aids
Overview
The MANUALplus 620 provides comprehensive internal
commissioning and diagnostic aids. It also includes highly effective
PC software for diagnosis, optimization and remote control.
ConfigDesign
(accessory)
PC software for configuring the machine parameters
•
Machine-parameter editor for the control; all support
information; additional data and input limits are shown for each
parameter
•
Configuration of machine parameters
•
Comparison of parameters from different controls
•
Importing of service files: easy testing of machine parameters in
the field
•
Rule-based creation and management of machine configurations
for multiple controls (together with PLCdesign)
DriveDiag
DriveDiag permits quick and easy troubleshooting of the drives.
The following diagnostic functions are available:
•
Reading and displaying the electronic ID labels of QSY motors
with EQN 13xx or ECN 13xx as well as the inverter modules
UVR 1xxD and UM 1xxD
•
Displaying and evaluating the internal control conditions and the
status signals of the inverter components
•
Displaying the analog values available to the drive controller
•
Automatic test for proper function of motors and inverters, of
position encoders and speed encoders
DriveDiag can be called directly from the control via the Diagnosis
soft key. It is also available for downloading as PC software
(accessory) from HESIS Web Including FileBase on the Internet.
End users have read-access, whereas the code number for the
machine tool builder gives access to comprehensive testing
possibilities with DriveDiag.
TNCopt
(accessory)
PC software for commissioning digital control loops:Functions:
•
Commissioning the current controller
•
Commissioning the velocity controller (automatic)
•
Optimization of sliding-friction compensation (automatic)
•
Optimization of the reversal-spike compensation (automatic)
•
Optimization of the k
V
factor (automatic)
•
Circular interpolation test, contour test
Online Monitor
(OLM)
The online monitor is a component part of the MANUALplus 620
and is called over a code number. It supports commissioning and
diagnosis of control components by:
•
Display of control-internal variables for axes and channels
•
Display of controller-internal variables (if a CC is present)
•
Display of hardware signal states
•
Various trace functions
•
Activation of spindle commands
•
Enabling control-internal debug outputs
To Next Page
Loading...
