60
Interfacing to the machine
Tool management
With integral PLC, the tool changer is moved either via proximity
switch or as a controlled axis. Tool management including tool life
monitoring and replacement tool monitoring is carried out by the
MANUALplus 620.
Tool calibration Tools can be measured and checked using the TT tool touch
probes (accessory). The control features standard cycles for
automatic tool measurement. The control calculates the probing
feed rate and the optimal spindle speed. The measured data is
stored in a tool table.
Touch probe
configuration
All touch-probe data can be configured conveniently through a
table. All HEIDENHAIN touch probe systems are preconfigured
and can be selected through a drop-down menu.
Magazine
management
The magazine management provides several functions for various
magazine types:
•
Loading and unloading of tools in chain-type magazines
•
Loading and unloading between magazine and spindle
•
Support for manual tools in manual magazines
•
Support for block search in tool magazines
To Next Page
Loading...
