9
POSITIP 880
Installation Instructions
Complete Operating Instructions available at www.heidenhain.de
3. Safety
The following messages provide safety information for preventing personal injury and
product damage:
Read and understand these instructions before use to avoid the possibility of
personal injury or death.
Hazardous live parts may be exposed if the product is opened. Do not open the
product. There are no serviceable items inside.
The protection provided by the equipment may be impaired if used in a manner
not specified. Do not use this product in any way other than it’s intended use.
Notice
For safety, operation and handling of the product, keep this document for future
reference.
4. Specifications
The POSITIP 880 is an advanced digital readout system for performing up to 6 axes
measurements at very high levels of precision and accuracy. This product is designed for
indoor use only. The POSITIP 880 components shall only be installed as described in these
instructions. Mounting, installation and maintenance are to be performed by qualified
personnel only.
Power input:
AC 100 V ... 240 V (-15 % ... +10 %)
50 Hz ... 60 Hz (±2 Hz)
(max. 35 W)
Replaceable fuse:
T 800 mA / 250 V, 5 mm x 20 mm
Environmental conditions
Operating temperature: 0 °C ... 45 °C
Storage temperature: -20 °C ... 70 °C
Relative humidity: 80 % RH
Altitude: 2000 m
Protection: IP40, front IP54
Overvoltage category: II, equipment intended to be supplied from the
building wiring
Pollution degree: 2
Mass: 3.2 kg
5. Mounting
Contents of Package
■ POSITIP 880 Digital Readout
■ Power Connect: 3-Pin IEC Connector (ID 257811-01)
■ Tilt/Swivel Kit (ID 382891-01)
■ Installation Instructions (ID 1084372-9x)
Do not mount in a position that makes it difficult to access the power switch or
power cable.
The POSITIP 880 may be mounted by attaching the product to a universal mounting arm
(ID 382929-01), or a mounting base (ID 382892-01). Refer to the Accessories section for
more information.
Notice
Refer to the documentation provided with the accessories for mounting
instructions.
Safety symbols
Where the following safety symbols
appear on the product they alert you to
important safety information.
Symbol description
9
Refer to the accompanying
information or
documentation to protect
against personal injury or
damage to the product
8
Earth (ground) terminal
1
Power switch “On (supply)”
position
1
Power switch “Off (supply)”
position
To Next Page
Loading...
