POSITIP 880 105
I – 9 POSITIP 880 Turning Functions
Press the INFO soft key.
Press the CALCULATOR soft key.
You will notice the soft key selection has changed and
now includes the TAPER CALCULATOR function.
Press the TAPER CALCULATOR soft key.
The soft key in this view toggles between D1/D2/
LENGTH and TAPER RADIUS methods. To calculate
the angle using two diameter lengths, press the D1/
D2 LENGTH soft key.
Using the numeric keys, enter data into DIAMETER 1
and DIAMETER 2 fields. Press ENT after each
selection.
Enter data into the LENGTH field, and the angle,
based on the calculations entered, will appear in the
ANGLE field.
To calculate angles using the ratio of the diameter to
the length, press the TAPER RATIO soft key.
Using the numeric keys, enter data into the RADIUS
and LENGTH fields. Press ENT after each selection.
The calculated ratio and the angle will appear in their
respective fields.
D1/D2 LENGTH
TAPER RATIO
To Next Page
Loading...
