POSITIP 880 21
I – 2 Working with POSITIP 880 – First Steps
Operating Modes
Selecting the operating mode determines which functions are
available to you.
You can switch to another operating mode at any time by pressing the
key for the desired mode.
In the following examples requiring tool usage, refer to chapter I-8
under Job Setup.
Available functions Mode Key
Position display for workpiece
machining; Zero reset; Datum
setting – also with edge finder probe
ACTUAL VALUE
Distance-to-go display; hole
patterns; milling and drilling with tool
radius compensation
DISTANCE-TO-GO
Storage of work steps for small-lot
production
PROGRAMMING
Run programs previously created in
the PROGRAMMING mode
EXECUTE PROGRAM
To Next Page
Loading...
