HEIDENHAIN POSITIP 880 - Page 133

POSITIP 880 133
II – 4 Data Interface
External Operations via RS-232 Data Interface
You can operate the display unit over the RS-232 data interface using
an external device. The following key commands are available:
Format
<ESC>TXXXX<CR> Key is pressed
<ESC>AXXXX<CR> Output of screen contents
<ESC>SXXXX<CR> Special functions
Sequence of commands Function
<ESC>T0000<CR> Key ‘0’
<ESC>T0001<CR> Key ‘1’
<ESC>T0002<CR> Key ‘2’
<ESC>T0003<CR> Key ‘3’
<ESC>T0004<CR> Key ‘4’
<ESC>T0005<CR> Key ‘5’
<ESC>T0006<CR> Key ‘6’
<ESC>T0007<CR> Key ‘7’
<ESC>T0008<CR> Key ‘8’
<ESC>T0009<CR> Key ‘9’
<ESC>T0100<CR> Key ‘CE’ or ‘CL’
<ESC>T0101<CR> Key ‘-’
<ESC>T0102<CR> Key ‘.’
<ESC>T0104<CR> Key ‘ENT’
<ESC>T0109<CR> Key ‘X’
<ESC>T0110<CR> Key ‘Y’/’Z’/’Z
0
’
<ESC>T0111<CR> Key ‘Z’
<ESC>T0112<CR> Key ‘IV”
<ESC>T0114<CR> Key ‘Soft key 1’
<ESC>T0115<CR> Key ‘Soft key 2’
<ESC>T0116<CR> Key ‘Soft key 3’
<ESC>T0117<CR> Key ‘Soft key 4’
<ESC>T0118<CR> Key ‘Soft key 5’
<ESC>T0119<CR> Key ‘Soft key 6’
<ESC>T0131<CR> Key ‘Nominal Value’
<ESC>T0132<CR> Key ‘Distance-to-go’
<ESC>T0133<CR> Key ‘PGM-Execution’
<ESC>T0134<CR> Key ‘PGM-Edit
<ESC>T0137<CR> Key ‘Cursor Up’
<ESC>T0138<CR> Key ‘Cursor Down’