16 I Operating Instructions
I – 1 Fundamentals of Positioning
A coordinate list corresponding to this example is useful when
working in the operating mode: PROGRAMMING. See Fig. I.8
Fig. I.8 Workpiece drawing with coordinate
dimensioning (ISO 129 or DIN 406 Part 11,
Fig. 179)
Coordinateorigin Dimensions in mm
Coordinates
Pos. X1 X2 Y1 Y2 r f d
1100 -
1 1.1 325 320 ø 120 H7
1 1.2 900 320 ø 120 H7
1 1.3 950 750 ø 200 H7
1 2 450 750 ø 200 H7
1 3 700 1225 ø 400 H8
2 2.1 -300 150 ø 50 H11
2 2.2 -300 0 ø 50 H11
2 2.3 -300 -150 ø 50 H11
3 3.1 250 0° ø 26
3 3.2 250 30° ø 26
3 3.3 250 60° ø 26
3 3.4 250 90° ø 26
3 3.5 250 120° ø 26
3 3.6 250 150° ø 26
3 3.7 250 180° ø 26
3 3.8 250 210° ø 26
3 3.9 250 240° ø 26
3 3.10 250 270° ø 26
3 3.11 250 300° ø 26
3 3.12 250 330° ø 26
To Next Page
Loading...
