POSITIP 880 29
I – 3 Actual Value
Datum setting with the edge finder
Preparation: Enter the stylus diameter and select the datum
8 Press the INFO soft key.
8 Press JOB SETUP, then cursor to EDGE FINDER and press ENT.
8 Enter the diameter of the edge finder stylus and confirm with ENT.
8 Enter the desired length and confirm with ENT.
8 Enter the desired unit of measurement (inch/mm).
8 Press USE, then USE NEW SETTINGS.
In all probing functions, POSITIP 880 takes into account the entered
stylus diameter.
To abort the probing function
While the probing function is active, POSITIP 880 displays the CANCEL
soft key. Choose this soft key to return to the opening state of the
selected probing function.
To Next Page
Loading...
