POSITIP 880 51
I – 5 Milling Patterns
Programming example: Mill rectangle pocket. See Fig. I.39 & Fig.
I.40.
Starting position: 2 mm
Milling depth: –20 mm
Pocket center in X: 50 mm
Pocket center in Y: 40 mm
Side length in X: 80 mm
Side length in Y: 60 mm
Direction: CCW
Finishing allowance: 0.5 mm
Example: Entering rectangle pocket data into a program
Operating mode: DISTANCE-TO-GO
Press FEATURES.
Press RECTANGLE POCKET.
Enter the start depth (2 mm). Press ENT.
Enter the end depth (- 20 mm).
Press ENT.
Enter the X and Y dimensions for the pocket center.
Press ENT.
Enter the X and Y dimensions for the side.
Press ENT.
Enter the direction of rotation (counter-clockwise).
Press ENT.
Fig. I.39 Rectangle pocket programming example
Fig. I.40 Rectangle pocket programming graphic
START DEPTH
END DEPTH
CENTER
SIZE
DIRECTION
To Next Page
Loading...
